A-2 ADAM-5510/P31
Quick Start Example
This chapter provides a description of the example project mentioned
in Chapter 0.
A.1 Example: Relay Output
Figure A-1 is the screen demonstration of this example. This is a
control program written in the ladder diagram control language.
1. When this program is started, only line 0001 is logically true (All 6
relays on ADAM-5060 have the same normal-close initial state). So
relay 0 is set (to 1) and the other relays are reset (to 0).
2. Once the logic states of the 6 relays are re-adjusted according to
the initial state, line 0001 turns false but line 0002 becomes true.
The logic state of lines 0003 to 0007 remain unchanged.
3. Line 0001 will delay 10 seconds before changing logic states to be
in accordance with the function block logic (S0R1 resets to 0)
Figure A-1: Example project to control ADAM-5060
To Next Page
Loading...