4 AI-5620 User Guide
• USB Flash drive containing TRsSim software, USB drivers, and Setup
software
• AI-5620 User Guide Manual
• TRsSim User Guide Manual
• Software License Key for TRsSim Application
• Calibration Certificate
If any of the above items are missing, contact your local sales representative or Advent
Instruments directly for replacement.
1.3 Important Safeguards and Safety Precautions
Please read all instructions and save them for future use. Observe the following
precautions to avoid injury and prevent damage to the AI-5620 or any products connected
to it. The AI-5620 is intended for use by qualified personnel who recognize shock
hazards and procedures to avoid possible electrical shock. The AI-5620 is designed for
use with electrical signals that are rated Measurement Category I as described in IEC
Standard 60664. All connectors and I/O are intended for connection to Category I
sources unless otherwise described in the manual.
• Ensure the AC power source is compatible with the voltage and frequency
requirements stated on the label on the rear of the unit.
• Do not operate the instrument with the case opened.
• Do not allow any liquid to enter the interior of the instrument.
• Observe all terminal ratings to avoid fire or shock hazards.
• Avoid exposed terminals. Do not touch exposed connections when power
is present.
• Do not operate with suspected failures. If damaged is suspected, do not
continue to operate the instruments until inspected by qualified service
personnel.
• Caution To reduce the risk of fire use only a No 26 AWG or larger
telecommunications line cord
• The instrument is intended for use in an indoor laboratory environment with
an altitude not to exceed 2000m. (Pollution Degree 2)
• To clean the instrument, disconnect it from the power supply, and then wipe
down the exterior with a cloth dampened with a mixture of mild detergent
and water. After the instrument is completely dry, the power supply may be
re-connected.
• Refer servicing to a trained personal only.
1.4 Powering on the AI-5620
Before powering on the AI-5620 for the first time, disconnect any cables connected to the
unit. The internal supply automatically adjusts to a wide range of input voltages and
To Next Page
Loading...