Page 10 AD Series Dehumidifying Dryers
1-4 Standard Features
; Dual desiccant beds
; Electrically-actuated air valve
; 13X Molecular Sieve
; Single regenerative process blower
; Drying temperature range of 160ºF to 400ºF.
; Mitsubishi programmable relay controller
; Display of process temperature set point and actual settings
; Process thermocouple to be connected to drying hopper air
inlet.
; Nema 12 control enclosure
• NFPA79 machinery electrical standards
• Non-fused electrical disconnect
• Branch fusing
• Mercury process heater contactor
• Regeneration temperature control
• Process high temperature alarm light
• Process/regeneration heater box
• High temperature safety system (Process/Regeneration)
1-5 Options
Options can tailor your AEC dehumidifying dryer to meet the
exact requirements of the drying task being performed.
; Process temperature up to 400ºF (or below 160ºF), including
aftercooler inside dryer and silicone insulated delivery hose.
Note: For below 160°F, cooler needs to be outside, between dryer and
drying hopper.
; If the dryer is a central dry air generator, it will not have a
process heater box.
; Plasticizer trap (with cooling coil) in lieu of standard
aftercooler (mounts outside on back of dryer).
; Machine mount adapter to accommodate a dryer and
corresponding hopper.
; Drawer magnet, stainless steel construction.
; Casters, two (2) fixed and two (2) swivel.
To Next Page
Loading...
