8 23.05 6755517_09
— Automatic restart after power failure
— Local or remote control
Display of unit status
— Power on
— Compressor ON/OFF
— Operating mode (heating/cooling)
— Alarm active
Display of sensors, transducers and parameters
— Water outlet temperature
— Water inlet
— Coil temperature (heat pump unit)
— Discharge refrigerant temperature
— External air temperature (heat pump, with DCPX and sensor)
— Discharge pressure (heat pump unit)
— Suction pressure (heat pump unit)
— Error from setpoint temperature (sum of the proportional and integral error)
— Delay time to start / stop the compressor
— Control of alarms
— Low pressure
— High pressure (pre-alarm: pressostat directly removes power to the compressor)
— High discharge temperature
— Anti-freeze
— Flow switch
— Alarm based on T
— Alarms with automatic reset and limited number of resets before denitive lock
out.
— ON/OFF control from remote contact
— Change of season from remote contact
For further information refer to the user manual.
To Next Page
Loading...
Need help?
General
