17
Fin Installation
1. Gather the Fin, Rudder and Hinges.
2. Mark cut lines on the covering were the bottom
of fin will glue to the top of the fuse.
Note: Cut lines should be thinner then the
thickness of the fin. This will prevent any
wood from showing after the fin as been
glued into place.
3. Using a hobby knife cut away covering to ex-
pose the wood at the top of the fuse for the fin to
securely glue too.
4. Put epoxy into the fin slot and top of fuselage.
Note: Test fit fin to fuse before gluing to ensure fin
is square to fuse.
To Next Page
Loading...
