87
1. The amount of control throw should be adjusted
using mechanical means as much as possible and
then electronically with the radio. The control
throws are shown in degrees and inches of de-
flection measured at the widest point of the con-
trol surface for both low and high rates.
2. Use the widest part of the aileron as shown to
measure the aileron throw in inches.
CONTROL THROWS
3. Use the widest part of the elevator as shown to
measure the elevator throw in inches.
4. Measure the rudder deflection in inches from the
rudder boost tab
Note: No inch measurements given for rudder.
Use Provide deflection meter to measure
rudder deflection in degrees.
5. Use the supplied flight control deflection meter
to measure the throws in degrees
. Prop up the
tail of the aircraft until the fuselage is
parallel to the table top.
6. Location for throw meter to measure Aileron
throw in degrees.
To Next Page
Loading...
