8
Hardware:
ITEMS NEEDED TO COMPLETE
• 50 CC Gas engine and ignition
• Pitts style muffler
• Engine mounting bolts, lock nuts, and washers.
• 3 1/2” Spinner and propeller of choice
• 4 x aileron servos (min 180 in./oz. Torque,
Digital, Metal geared) Rec. HS5985-MG
• 1 x rudder servo (min 180 in./oz. Torque,
Digital, Metal geared) Rec. HS5985-MG
• 2 x elevator servos (min 180 in./oz. Torque,
Digital, Metal geared) Rec. HS5985-MG
• 1 x throttle servo (Fast / Reliable)
• 1 x choke servo (Fast / Reliable) optional
• Servo extensions 9 x 6,” 2 x 24,” 2 x 11” Y’s
• 1 x 8 channel receiver ( PCM recommended)
• 1 x receiver battery (min 6.0 volt / 1700ma)
• 1 x ignition battery (min 4.8 volt / 1700ma)
• 2 x switches with charge jacks
Tools:
• Allen wrenches US and Metric.
• Dremel cutting disc and sanding drum tool
• Electric drill and selection of bits
•
Razor saw
•
Flat head screwdriver
•
Hobby heat gun
•
Hobby iron and covering sock
• Masking tape
• Modeling knife
• Needle nose pliers or crimping tool
•
Paper towels
•
Pen, pencil or felt tipped marker
• Phillips screwdriver
• Rubbing alcohol
• Ruler and tape measure
• Scissors
• T pins
• Waxed paper
• Wire Cutters
Adhesives:
• 15-30 Minute epoxy
• Blue Loctite
• Epoxy mixing cups, mixing sticks, brushes
•
CA kicker (optional)
• Thick, Thin and Medium CA
• Rubbing alcohol
• Wipes
WARNIN G
Some rubbing alcohols
may attack painted parts.
To Next Page