36
3. Mount the tail wheel steering tiller using two
wood screws. Apply a drop of thick CA to the
mounting screws before inserting into the tiller
mounting holes.
4. Tighten wood screws and secure in place.
5. Place the tail wheel leaf spring on top of the tail
wheel strut. Position the tail wheel and spring
on the bottom of the fuse over the pre-drilled
mounting holes.
6. Mount the tail wheel strut using three wood
screws. Place a drop of thick CA on tail wheel
strut mounting screws before inserting in the
pre-drilled mounting holes on the bottom rear of
the fuse.
To Next Page
Loading...
