50
5. Attach ball link to throttle arm of carburetor
6. Assemble brass threaded coupler to 4-40 ball
link and Ball link and brass spacer to the servo
arm as shown below.
7. Assemble servo arm to servo at 90 degrees to
servo. Drop servo into provided servo mounting
slot in fuse with servo out put shaft to the rear.
Align throttle servo with throttle pushrod and
mark servo mounting location
8. With servo arm still 90 degrees to servo and
throttle arm of carburetor in the center or half
throttle position. Mark the length needed for the
throttle push rod.
To Next Page
Loading...
