25
2241A EN 20040210
Switching off the CR 75.0
Before switching off
Check that the CR 75.0 is not scanning an image plate. If the CR 75.0 is
scanning an image plate, the status indicator at the top of the machine is
green and flashing.
Switching off
It is recommended to switch off the CR 75.0 at the end of the day.
Place the main switch in position ‘OFF’.
Only switch off the CR 75.0 if you do not intend to digitize emergency
image plates overnight. Switching on the CR 75.0 takes a few minutes.
During this time emergency digitizing is not possible!
To Next Page
Loading...
