AGFA CR 75.0 - Setting the Date and Time

48
2241A EN 20040210
Setting the date and time
To set the clock of the CR 75.0:
1 In the key-operator main menu, select ‘Date and time’ via the Up and Down
keys and confirm.
The CR 75.0 will display the Date and time menu:
# If you do not press a key within 1 minute, the CR 75.0 will exit the key-
operator mode.
2 Set the date and time:
• Use the Left and Right keys to select the digit you want to change (‘tab’);
• Use the Up and Down keys to set the digit to the desired value (‘inc. dec.’).
3 Confirm the date and time.
The operator main screen is displayed.
Queue management
Digitizer set-up
Date and Time
Send test image
System info
Install
Save configuration
Fast preview
: quit
: ok
: select
KEY-OPERATOR
MENU
SERVICE XXXXX
Format:
YY- MM- DD HH : MM: SS
98 -11 - 06 14 : 24 : 58
: quit
: ok
: tab
: inc. dec.
DATE AND
TIME
SERVICE XXXXX