AGFA CR 75.0 - Customizing the CR 75.0 (Digitizer Set-Up)

42
2241A EN 20040210
Customizing the CR 75.0 (‘Digitizer set-up’)
Via the Digitizer set-up function in key-operator mode, you can:
• enable or disable the transmittal of images to all image processing stations;
• reroute images to another image processing station (‘destination’);
• enable or disable all audio signals.
Enabling/disabling image transmission
1
In the key-operator main menu, select ‘Digitizer set-up’ via the Up and Down
keys and confirm.
The CR 75.0 will display the Digitizer set-up menu:
# If you do not press a key within 1 minute, the CR 75.0 will exit the key-
operator mode.
Queue management
Digitizer set-up
Date and Time
Send test image
System info
Install
Save configuration
Fast preview
: quit
: ok
: select
KEY-OPERATOR
MENU
SERVICE XXXXX
Process.station: enabled
Reroute process.station
[PPname1]
to
[PPname2]
Scan mode: standard
Acoustic signal: enabled
: quit
: ok
: select
: change
DIGITIZER
SET-UP
SERVICE XXXXX
Image
transmission
field