33
2241A EN 20040210
2 Press the Erase key on the keypad.
The display will read:
3 Use the Up and Down keys to set the number of image plates to be erased.
The default value is 1; the maximum is 9.
4 Place the cassettes which you want to erase in the cassette input buffer.
After a cassette has been erased, the # digit on the display decreases.
While erasing, the CR 75.0 will still display the above screen and the status
indicator will be green flashing. When the CR 75.0 has erased the image plate, it
displays the operator main screen.
You can now add (exposed) cassettes to the batch of cassettes. The Digitizer will
only erase as many cassettes as you have specified.
If you place fewer cassettes in the cassette input buffer than you have specified, the
Digitizer will erase the cassettes in the buffer and revert to normal mode after a
time-out of 1 minute.
READY
ERASURE
WARNING
The next cassette(s) will be erased
Enter number of cassettes to erase: #
Put cassette(s) in input buffer or
press to quit.
To Next Page
Loading...
