AGFA CR 75.0 - Page 44

44
2241A EN 20040210
Changing the destination
If an image processing station is out of operation, you can reroute the images
to another image processing station. Start as in ‘Enabling/disabling image
transmission’ on page 42:
1 In the key-operator main menu, select ‘Digitizer set-up’ via the Up and Down
keys and confirm.
The CR 75.0 will display the Digitizer set-up menu:
# If you do not press a key within 1 minute, the CR 75.0 will exit the key-
operator mode.
2 Select the Source rerouting field via the Up and Down keys.
3 Select the image processing station from which you want to redirect the
images via the Left and Right keys.
# You can only redirect the images of one image processing station.
4 Select the Target rerouting field via the Up and Down keys.
Queue management
Digitizer set-up
Date and Time
Send test image
System info
Install
Save configuration
Fast preview
: quit
: ok
: select
KEY-OPERATOR
MENU
SERVICE XXXXX
Process.station: enabled
Reroute process.station
[PPname1]
to
[PPname2]
Scan mode: standard
Acoustic signal: enabled
: quit
: ok
: select
: change
DIGITIZER
SET-UP
SERVICE XXXXX
T
arget rerouting
f
ield
Source rerouting
field