DR Detector Calibration|Calibrating the DR Detector|8
DR 10e C, DR 14e C, DR 17e C A single set of calibration data is used for all NX work-
stations on which the DR Detector is used. Choose one
NX workstation that will be used for calibration and
perform the regular calibration each time on the same
NX workstation.
Do not calibrate the DR Detector on another NX work-
station.
DR 18M, DR 24M
Fixed DR Detector
The DR Detector can only be used on a single NX work-
station.
Note If the system has multiple DR Detectors, make a note of the ID that is mentioned in the
message on the NX workstation indicating which of the DR Detectors must be calibrated. The
ID is required to identify the right detector during calibration.
0134KEN20240524 1323
To Next Page
Loading...
