141
Chapter 3 Features and Functions
Remote Interface Configuration
3
Domain Name (LAN) A domain name is a registered name on the
Internet, which is translated into an IP address.
• Contact your network administrator for the correct domain name.
• Enter the domain name using the knob and cursor keys. Each
character can be a letter ("a" through "z"), number, dash ("_"), or
period (“.”).
• Use the knob to select each character.
• Use the cursor key to move to the next character.
• You can use the keypad for numbers.
• Use the key to delete all characters to the right, starting at
the cursor position.
• The host name is stored in non-volatile memory and does not change
when power has been off or after a remote interface reset.
• Front panel operation: Press and press the I/O softkey. Select
LAN, then Modify Settings, followed by DNS Setup. Then select
Domain Name and enter the domain name.
• There is no SCPI command to set a domain name.
DNS Server (LAN) DNS (Domain Name Service) is an Internet service
that translates Domain names into IP addresses. The DNS server
address is the IP address of a server that performs this service.
• Contact your network administrator to find out whether DNS is being
used, and for the correct DNS server address.
• Enter the address using the numeric keypad (not the knob).
• The DNS server address is stored in non-volatile memory and does
not change when power has been off or after a remote interface reset.
• Front panel operation: Press and press the I/O softkey. Select
LAN, then Modify Settings, followed by DNS Setup. Then select DNS
Server and enter the server address.
• There is no SCPI command to set a DNS server address.
To Next Page
Loading...
Need help?
General
