Agilent Technologies 33220A

67
Chapter 3 Features and Functions
Output Configuration
3
• Remote Interface Operation:
OUTPut {OFF|ON}
The APPLy command overrides the current setting and automatically
enables the Output connector.
Waveform Polarity
In the normal mode (default), the waveform goes positive during the first
part of the cycle. In the inverted mode, the waveform goes negative
during the first part of the cycle.
• As shown in the examples below, the waveform is inverted relative to
the offset voltage. Any offset voltage present will remain unchanged
when the waveform is inverted.
• When a waveform is inverted, the Sync signal associated with the
waveform is not inverted.
• Front-Panel Operation: Press and select the Output Setup
softkey. Then press the Normal softkey again to toggle between the
“Normal” and “Invert” selections.
• Remote Interface Operation:
OUTPut:POLarity {NORMal|INVerted}
No Offset Voltage With Offset Voltage
Inverted
N
ormal
0V
Inverted
0V
Normal
Offset