Agilent Technologies 33220A

161
Chapter 4 Remote Interface Reference
SCPI Command Summary
4
Command Summary
(see page 223 for more information)
BURSt:MODE {TRIGgered|GATed}
BURSt:MODE?
BURSt:NCYCles {<
# cycles>|INFinity|MINimum|MAXimum}
BURSt:NCYCles? [MINimum|MAXimum]
BURSt:INTernal:PERiod {<
seconds>|MINimum|MAXimum}
BURSt:INTernal:PERiod? [MINimum|MAXimum]
BURSt:PHASe {<
angle>|MINimum|MAXimum}
BURSt:PHASe? [MINimum|MAXimum]
BURSt:STATe {OFF|ON}
BURSt:STATe?
UNIT:ANGLe {DEGree|RADian}
UNIT:ANGLe?
TRIGger:SOURce {IMMediate|EXTernal|BUS} Triggered Burst
TRIGger:SOURce?
TRIGger:SLOPe {POSitive|NEGative} “Trig In” Connector
TRIGger:SLOPe?
BURSt:GATE:POLarity {NORMal|INVerted} External Gated Burst
BURSt:GATE:POLarity?
OUTPut
:TRIGger:SLOPe {POSitive|NEGative} “Trig Out” Connector
:TRIGger:SLOPe?
:TRIGger {OFF|ON}
:TRIGger?
Burst Commands
Parameters shown in bold are selected following a *RST (reset) command.