256
Chapter 4 Remote Interface Reference
Interface Configuration Commands
4
SYSTem:COMMunicate:LAN:LIPaddress?
Returns the “last valid Auto IP address used” in dot notation (for
example: “169.254.20.11”).
SYSTem:COMMunicate:LAN:MAC?
Returns the 33220A’s Media Access Control (MAC) address. This is an
unchangeable 48-bit address assigned by the manufacturer to each
unique internet device. The MAC address is represented as 12
hexadecimal characters in the form “XX-XX-XX-XX-XX-XX” (for
example, “00-30-D3-00-10-41”).
SYSTem:COMMunicate:LAN:MEDiasense {OFF|0|ON|1}
SYSTem:COMMunicate:LAN:MEDiasense?
Disables or enables the MEDiasense feature. When enabled, this feature
detects a loss of LAN connectivity greater than 20 seconds, and then, on
sensing a reconnection, re-starts the LAN. The factory setting is enabled
(ON). The query returns “0” (OFF) or “1” (ON).
• If you change the MEDiasense setting, you must cycle power on the
instrument to activate the new setting.
• The MEDiasense setting is stored in non-volatile memory, and does
not change when power has been off, or after a instrument reset
(*RST).
SYSTem:COMMunicate:LAN:NETBios {OFF|0|ON|1}
SYSTem:COMMunicate:LAN:NETBios?
Disables or enables the use of NETBios to automatically assign an IP
address to the 33220A for peer-to-peer naming on a private network that
uses the NETBios naming service. The factory setting is enabled (ON).
The query returns “0” (OFF) or “1” (ON).
• If you change the NETBios setting, you must cycle power on the
instrument to activate the new setting.
• The NETBios setting is stored in non-volatile memory, and does not
change when power has been off, or after a instrument reset (*RST).
To Next Page
Loading...
