Installation
Agilent 5100 and 5110 ICP-OES User’s Guide 39
SPS 4
See the instructions that came with the accessory for safety
information and to prepare the SPS 4 for installation.
The SPS 4 is compatible with a wide range of commercially available
low-cost autoclavable sample racks.
Sample contamination from airborne particles is eliminated and
corrosive or toxic fumes are removed during sampling with the
optional environmental enclosure.
SPS 3
For safety information and to prepare the Sample Preparation
System (SPS 3) for installation, please see the instructions that came
with the accessory.
The SPS 3 is compatible with a wide range of commercially available
low-cost autoclavable sample racks.
Sample contamination from airborne particles is eliminated and
corrosive or toxic fumes are removed during sampling with the
optional environmental enclosure.
Advanced Valve System (AVS) — AVS 4, AVS 6 and AVS 7
For safety information and to prepare the accessory for installation,
please see the instructions that came with the accessory.
The integrated AVS 4 (4 port switching valve) rinses the sample
introduction system while the next sample is being presented to the
instrument prior to measurement. Excess sample is diverted away
from the spray chamber and rinse is introduced immediately after
measurement. This will reduce sample carry-over and required
cleaning frequency of sample introduction components.
To Next Page
Loading...
Need help?
General
