Installation
32 Agilent 5100 and 5110 ICP-OES User’s Guide
Saving and viewing the calibration data
The calibration data is stored in the Logs. To view the data, export
the Logs.
1 From the main ICP Expert window, click File > Logs > Export
Logs.
2 Save the zipped Log file.
3 Open the .zip file to view the Log files.
NOTE
The default save location is \Users\’Username’\Documents\Agilent\ICP
Expert\Exported Results\ on the drive on which the ICP Expert software is
installed.
Hardware Components Replacement
Your ICP-OES should be ready to operate after the Agilent field
service engineer has installed it. However, you may need to set up
items such as the peristaltic pump, nebulizer, torch or spray
chamber. For instructions on how to do this, please refer to the
ICP-OES Familiarization DVD or the ‘How to’ section in the ICP
Expert Help.
To Next Page
Loading...
Need help?
General
