Agilent 5890 2 Requirements
2 Requirements
Clarity Installation CD ROM with GC Control module (p/n A23).
Caution: The control module does not support EPC, FPD and Analog Input
Board (19261-60010)
Free serial port in the PC (fast - 16550 UART).
Note: Modern computers usually have only 1 (if any) serial (COM) port installed.
To use more devices requiring the port, the MultiCOM adapter (p/n
MC01) is available.
Serial cross DB9F-DB25M cable (p/n SK03).
Note: Cables are not part of Clarity Control Module. It is strongly
recommended to order required cables together with the Control Module.
HPIB/RS232 Interface card set for HP 5890. Can be only obtained from
Agilent or third parties.
Caution: Check the Control Board compatibility table in the chapter "Agilent
5890 GC Control Module" on pg 1.
Note: The Interface card set includes the HP IB/RS232 Ribbon Cable (p/n
KB58-1, Agilent order No. 19257- 60500), Back Panel (p/n KB58 2,
Agilent order No. 19257- 60020) and the Interface card (p/n KB58-3,
Agilent order No. 19257-60015). When using the HPIB card from Agilent,
the Ribbon Cable and Back panel have to be ordered separately.
- 2 -