Chapter 3 Front-Panel Operation
Remote Interface Configuration
50
5 Save the change and turn off the I/O configuration mode.
The RS-232 baud rate and parity selections are stored in non-volatile memory, and
does not change when power has been off or after a remote interface reset. The power
supply displays a message to show that the change is now in effect. If the baud rate
and the parity are not changed, “NO CHANGE” will be displayed for one second.
Note To exit the I/O configuration mode without any further changes, press the “I/O
Config” key until the “NO CHANGE” message is displayed.
CHANGE SAVED
To Next Page
Loading...
Need help?
General
