4-18 Chapter4
Troubleshooting
Informational Messages
Default spur table values loaded.
No spur table has been previously saved when the
Out-of-Band Spurious measurement begins. Press Meas
Setup, Edit Table to enter the frequency ranges of
interest and press
Save Table to save that information.
This saved table will be loaded the next time the
measurement is run.
Device = Mobile. Code Domain not available.
Code Domain measurement is grayed out when the
device is set to mobile under the Mode Setup front-panel
key. Code Domain measurement is only accessible when
the device is set to base and Digital Signal Processing
and Fast Analog to Digital Converter (Option B7D) or
RF Communications Hardware (Option B7E) are
installed.
Device = Mobile. Mod Acc not available.
Modulation accuracy measurement is grayed out when
the device is set to mobile under
Mode Setup,
front-panel key. Modulation accuracy is only accessible
when the device is set to base and Digital Signal
Processing and Fast Analog to Digital Converter
(Option B7D) or RF Communications Hardware
(Option B7E) are installed.
Directory already exists
Each directory and file must have a unique name. The
directory name you have entered is currently being
used on the selected drive. You may either enter a new
name or rename the directory currently existent. Refer
to “File Menu Functions” on page 2-25.
Entire trace is below the threshold level.
The measurement cannot operate properly because the
trace has fallen completely below the threshold level.
To Next Page
Loading...
Need help?
General
