Chapter 4 4-19
Troubleshooting
Informational Messages
Measurement halted. Press a measurement key to
continue.
This error occurs after you choose Cancel to refrain
from setting the attenuator to 0 dB during the Receive
Channel Power and Receive Spur measurements.
Not enough frequency range to measure
harmonics for channel.
Selected harmonics are above the frequency range of
the instrument.
Option activated
This message is displayed after entering the selected
option’s License Key.
Please set RF input range (INPUT menu) to
manual first.
In order to manually set the reference level and/or the
attenuation under the
Amplitude front-panel key, the
RF Input Range menu under the
Input front-panel key
must be set to
Man (manual).
Table loaded successfully.
When the
Load Table key was pressed on the second
page of the edit table form while in the out-of-band
spurious measurement, the file was present. The
information has been loaded into the measurement
where it may be edited again by the user. This message
will also appear when the out-of-band spurious
measurement is opened if a spur table has been
previously saved.
Table saved successfully.
This message appears after the user presses the
Save Table key on the second page of the edit table for
the out-of-band spurious measurement. It indicates
that the current spur table has been written
successfully to disk and is available to be loaded by
means of the
Load Table key.
To Next Page
Loading...
Need help?
General
