Chapter 4 4-51
Troubleshooting
Greater than 1000: Personality Specific Error Messages
10239 Opt Freq Ref setting does not match external
reference.
This message is generated if Source is set to External
on the properties form under the front-panel
Mode
Setup key and the frequency on the same form is set to
a frequency that does not match the frequency of the
signal being used as the external reference.
10232 RF Signal not found.
This message is generated if there is no signal at the
center frequency that is greater than 10 dB above the
displayed average noise level.
10241 RF Board could not detect any bursts in
signal.
This message is generated when the trigger is set to RF
Burst and (Option B7E) cannot detect a burst.
10237 RF Board LO Unlocked. Contact service center.
This message occurs if the local oscillator on the
(Option B7E) is in an unlocked state. This indicates
broken hardware.
10240 RF Board RF Osc Unlocked. Contact service
center.
This message occurs if the reference oscillator on the
(Option B7E) is in an unlocked state. This indicates
broken hardware.
10238 RF Board SR Osc Unlocked. Contact service
center.
This message occurs if the sample rate oscillator on
Option B7E is in an unlocked state. This indicates
broken hardware.
10162 Resolution BW<300kHz.
This error message is a warning that the resolution
bandwidth has been set below 300 kHz. The test results
will not meet GSM specifications.
To Next Page
Loading...
Need help?
General
