4-50 Chapter4
Troubleshooting
Greater than 1000: Personality Specific Error Messages
10149 Opt BAH DSP algorithm code file requires
upgrade.
The Digital Signal Processing algorithm code file
revision is not supported by the currently loaded
personality version. Refer to the user’s guide for the
personality in use for more information on
installation/upgrade.
10150 Opt BAH DSP algorithm coef. file requires
upgrade.
The Digital Signal Processor algorithm coefficient file
revision is not supported by the currently loaded
personality version. Refer to the user’s guide for the
personality in use.
10151 Opt BAH DSP algorithm files failed to load,
aborting measure.
The Digital Signal Processor algorithm files required to
perform the demodulation are corrupt and cannot be
loaded properly. Reinstall measurement personality.
10148 Opt BAH DSP algorithm files not installed.
Meas unavailable.
The Digital Signal Processor algorithm files required to
perform the demodulation are not present in the
analyzer.
10145 Opt AYX hardware required. Meas unavailable.
Option AYX must be installed for this measurement to
be enabled.
10146 Opt B7D & B7E hardware required. Meas
unavailable.
The (Option B7E) and (Option B7D) cards required to
perform the demodulation are not present in the
analyzer.
To Next Page
Loading...
Need help?
General
