Chapter 4
Front-Panel Key and SCPI Command Reference
Measurement keys
181
Front-Panel Key and SCPI Command
Reference
4.4.2.2.3 Use Power Meter
Selects whether an external power meter is used, if yes the RF RMS power is measured, else RF Peak power is
measured.
4.4.3 Tuned RF Level Measurement
There is only one view available for Tuned RF Level measurement. There are two windows:
• Tuned RF Level Numeric Results Window (upper)
• Measurement Settings window (lower)
Example: :RFP:AVER:TYPE EXP
:RFP:AVER:TYPE?
Mode: MRECEIVE
Key Path:
Mode Setup
Remote Command: [:SENSe]:RFPower:PMETer:USE YES|NO
[:SENSe]:RFPower:PMETer:USE?
Preset: YES
State Saved: Saved in instrument state.
Range: Yes | no
Remote Command Notes: Global to the current mode.
Example: :RFP:PMET:USE NO
:RFP:PMET:USE?
Table 4-9 Tuned RF Level Measurement Result Window
Name Corresponding Results
Tuned RF level n=1 1st
Table 4-10 Tuned RF Level Setting Metrics Window
Name Corresponding Results
IFBW It is the value of IFBW
Display Mode It can be Normal or Ratio
Ratio Reference It is the reference value for Ratio mode
Ratio Mode It can be Log or Linear
To Next Page
Loading...
Need help?
General
