6-2 Service Guide E8364-90038
Replaceable Parts PNA Series Microwave Network Analyzers
Information in This Chapter E8362C, E8363C, E8364C
Information in This Chapter
This chapter:
• identifies the replaceable parts for the Agilent PNA series microwave network analyzers.
• includes several tables and illustrations to assist you in identifying the correct part for your analyzer.
• contains ordering information for new assemblies and rebuilt-exchange assemblies.
How to Use the Replaceable Parts Listings in This Chapter
There are multiple replaceable parts listings in this chapter for top and bottom assemblies and top and
bottom cables. When searching for the part number for a specific item, it is necessary to use both the “No
Options” listing and the “Options” listing that applies to your analyzer.
For example: If your analyzer has option UNL installed, and you need the part number for a replaceable
assembly on the bottom of the analyzer, you would refer to both “Bottom Assemblies, No Options”
on page 6-22 and “Bottom Assemblies, Option UNL” on page 6-26. If the same part is listed in both lists, part
numbers listed in the “Options” listing supersede those in the “No Options” listing.
Chapter Six at-a-Glance
Section Title Summary of Content Start Page
Ordering Information How to order a replaceable part from Agilent
Te ch n ol o g ie s .
Page 6-3
Assembly Replacement Sequence The correct sequence for replacing a defective assembly. Page 6-4
Rebuilt-Exchange Assemblies
The definition of a rebuilt-exchange assembly.
The procedure for replacing and returning a defective
assembly to Agilent Technologies.77
Page 6-5
Replaceable Parts Listings
This section lists the assemblies by their reference
number and illustrates the location of the replaceable
parts in the analyzer, including:
• Assemblies (front panel, top, and bottom)
• Cables (top and bottom)
• Options (parts included with options)
• Hardware (internal, hard disk drive, rear panel, and
external)
Page 6-6
To Next Page
Loading...
Need help?
General
