50 Chapter 1
Introduction to Programming X-Series Applications
STATus Subsystem (Remote Only Commands)
Questionable Calibration Skipped Enable This command determines which bits in the
Questionable Calibration Skipped Condition Register will set bits in the Questionable
Calibration Skipped Event register, which also sets bit 11 of the Questionable Calibration
Register. The variable <integer> is the sum of the decimal values of the bits you want to
enable.
Questionable Calibration Skipped Event Query This query returns the decimal value of the
sum of the bits in the Questionable Calibration Event register.
NOTE The register requires that the associated PTR or NTR filters be set
before a condition register bit can set a bit in the event register. The
data in this register is latched until it is queried. Once queried, the
register is cleared.
Remote Command :STATus:QUEStionable:CALibration:SKIPped:CONDition?
Example STAT:QUES:CAL:SKIP:COND?
Preset 0
SCPI Status Bits/OPC
Dependencies
Sequential command
Mode All
Remote Command :STATus:QUEStionable:CALibration:SKIPped:ENABle
<integer>
:STATus:QUEStionable:CALibration:SKIPped:ENABle?
Example STAT:QUES:CAL:SKIP:ENAB 1 Can be used to query if an
EMI alignment skipped condition is detected
Preset 32767
Min 0
Max 32767
SCPI Status Bits/OPC
Dependencies
Sequential command
Mode All
Remote Command :STATus:QUEStionable:CALibration:SKIPped[:EVENt]?
Example STAT:QUES:CAL:SKIP?
Preset 0
SCPI Status Bits/OPC
Dependencies
Sequential command
To Next Page
Loading...
