52 Chapter 1
Introduction to Programming X-Series Applications
STATus Subsystem (Remote Only Commands)
NOTE The data in this register is continuously updated and reflects the
current conditions.
Questionable Calibration Extended Failure Enable This command determines which bits in
the Questionable Calibration Extended Failure Condition Register will set bits in the
Questionable Calibration Extended Failure Event register, which also sets bit 9 of the
Questionable Calibration Register. The variable <integer> is the sum of the decimal values
of the bits you want to enable.
Questionable Calibration Extended Failure Event Query This query returns the decimal
value of the sum of the bits in the Questionable Calibration Extended Failure Event
register.
NOTE The register requires that the associated PTR or NTR filters be set
before a condition register bit can set a bit in the event register. The
data in this register is latched until it is queried. Once queried, the
Mode All
Remote
Command
:STATus:QUEStionable:CALibration:EXTended:FAILure:CONDition?
Example STAT:QUES:CAL:EXT:FAIL:COND?
Preset 0
SCPI
Status
Bits/OPC
Dependenci
es
Sequential command
Mode All
Remote Command :STATus:QUEStionable:CALibration:EXTended:FAILure:ENABle
<integer>
:STATus:QUEStionable:CALibration:EXTended:FAILure:ENABle?
Example STAT:QUES:CAL:EXT:FAIL:ENAB 1 Can be used to query if an EMI
conducted alignment is needed.
Preset 32767
Min 0
Max 32767
SCPI Status Bits/OPC
Dependencies
Sequential command
To Next Page
Loading...
