Chapter 1 53
Introduction to Programming X-Series Applications
STATus Subsystem (Remote Only Commands)
register is cleared.
Questionable Calibration Extended Failure Negative Transition This command determines
which bits in the Questionable Calibration Extended Failure Condition register will set
the corresponding bit in the Questionable Calibration Extended Failure Event register
when the condition register bit has a negative transition (1 to 0). The variable <integer> is
the sum of the decimal values of the bits that you want to enable.
Questionable Calibration Extended Failure Positive Transition This command determines
which bits in the Questionable Calibration Extended Failure Condition register will set
the corresponding bit in the Questionable Calibration Extended Failure Event register
when the condition register bit has a positive transition (0 to 1). The variable <integer> is
the sum of the decimal values of the bits that you want to enable.
Mode All
Remote
Command
:STATus:QUEStionable:CALibration:EXTended:FAILure[:EVENt]?
Example STAT:QUES:CAL:EXT:FAIL?
Preset 0
SCPI Status
Bits/OPC
Dependencies
Sequential command
Mode All
Remote Command :STATus:QUEStionable:CALibration:EXTended:FAILure:NTRansition
<integer>
:STATus:QUEStionable:CALibration:EXTended:FAILure:NTRansition?
Example STAT:QUES:CAL:EXT:FAIL:NTR 1 EMI conducted align failure is not
required.
Preset 0
Min 0
Max 32767
SCPI Status Bits/OPC
Dependencies
Sequential command
Mode All
Remote
Command
:STATus:QUEStionable:CALibration:EXTended:FAILure:PTRansition
<integer>
:STATus:QUEStionable:CALibration:EXTended:FAILure:PTRansition?
Example STAT:QUES:CAL:EXT:FAIL:PTR 1 EMI conducted align failure is required.
To Next Page
Loading...
