Chapter 1 65
Introduction to Programming X-Series Applications
STATus Subsystem (Remote Only Commands)
Questionable Power Register
Questionable Power Condition his query returns the decimal value of the sum of the bits in
the Questionable Power Condition register.
NOTE The data in this register is continuously updated and reflects the
current conditions.
Questionable Power Enable This command determines which bits in the Questionable
Power Condition Register will set bits in the Questionable Power Event register, which
also sets the Power Summary bit (bit 3) in the Questionable Register. The variable
<integer> is the sum of the decimal values of the bits you want to enable.
Questionable Power Event Query This query returns the decimal value of the sum of the
bits in the Questionable Power Event register.
NOTE he register requires that the associated PTR or NTR filters be set before
a condition register bit can set a bit in the event register. The data in
SCPI Status Bits/OPC
Dependencies
Sequential command
Mode All
Remote Command :STATus:QUEStionable:POWer:CONDition?
Example STAT:QUES:POW:COND?
Preset 0
SCPI Status Bits/OPC
Dependencies
Sequential command
Mode All
Remote Command :STATus:QUEStionable:POWer:ENABle <integer>
:STATus:QUEStionable:POWer:ENABle?
Example STAT:QUES:POW:ENAB 32 50 MHz Input Pwr too High for
Cal will be reported to the Power Summary of the Status
Questionable register.
Preset 32767
Min 0
Max 32767
SCPI Status Bits/OPC
Dependencies
Sequential command
To Next Page
Loading...
