Agilent Technologies EXA N9010A - Page 66

66 Chapter 1
Introduction to Programming X-Series Applications
STATus Subsystem (Remote Only Commands)
this register is latched until it is queried. Once queried, the register is
cleared.
Questionable Power Negative Transition This command determines which bits in the
Questionable Power Condition register will set the corresponding bit in the Questionable
Power Event register when the condition register bit has a negative transition (1 to 0). The
variable <integer> is the sum of the decimal values of the bits that you want to enable.
Questionable Power Positive Transition This command determines which bits in the
Questionable Power Condition register will set the corresponding bit in the Questionable
Power Event register when the condition register bit has a positive transition (0 to 1). The
variable <integer> is the sum of the decimal values of the bits that you want to enable.
Mode All
Remote Command :STATus:QUEStionable:POWer[:EVENt]?
Example STAT:QUES:POW?
Preset 0
SCPI Status Bits/OPC
Dependencies
Sequential command
Mode All
Remote Command :STATus:QUEStionable:POWer:NTRansition <integer>
:STATus:QUEStionable:POWer:NTRansition?
Example STAT:QUES:POW:NTR 32 50 MHz Input Power became OK
for Cal will be reported to the Power Summary of the Status
Questionable register.
Preset 0
Min 0
Max 32767
SCPI Status Bits/OPC
Dependencies
Sequential command
Mode All
Remote Command :STATus:QUEStionable:POWer:PTRansition <integer>
:STATus:QUEStionable:POWer:PTRansition?>
Example STAT:QUES:POW:PTR 32 50 MHz Input Power became too
high for Cal will be reported to the Power Summary of the
Status Questionable register.
Preset 32767