4. The flat edge of the fuse holder has two different voltage labels (115V
and
230V) printed in opposite orientation to each other. With the voltage
labels facing out, insert the fuse holder into the fuse box so that the label
for the desired voltage is in the proper orientation. (If your instrument is
100-120 volts, insert the fuse holder such that the
115V label is right-
side-up. If your instrument is 200-240 volts, insert the fuse holder such
that the
230V label is right-side-up.)
5. Replace the cover on the fuse box. Verify that the correct voltage label
is visible through the cover.
Mx3000P and Mx3005P QPCR Systems Setup and User’s Guide 5
To Next Page
Loading...
Need help?
General
