Making Your First Measurements
Running a WLAN Confidence Check
Chapter 230
If you have previously installed the N4010A Wireless LAN Test Suite, the Agilent I/O
Libraries Suite software and the Microsoft .NET Framework service pack 1, using
the procedure described in the N4010A CD-ROM Installation Guide, you can
proceed directly to Step 2.
Step 1. Install the N4010A Wireless LAN Test Suite.
1. Insert the N4010A Measurement Software, Applications and Operating
INformation CD-ROM into your PC drive.
If the CD does not auto-start, from your task bar select Start > Run. In the field
enter <CDdrive>:\setup where <CDdrive> is the letter of your CD drive.
2. Follow the on-screen instructions. The installation requires a reboot of the PC in
this process.
Step 2. Refer to “Connecting USB, GPIB or LAN” on page 18.
NOTE For the WLAN test program, LAN or USB are the recommended connection
solutions. GPIB can be used, however, due to its lower data rate transfer is not
suitable for some features of WLAN testing.
N4010-90086.book Page 30 Monday, November 18, 2013 9:20 AM
To Next Page
Loading...
Need help?
General
