Technical Information
TwisTorr 74 FS On Board Controller Installation
TwisTorr 74 FS User Manual / 87-901-053-01 321/342
TwisTorr 74 FS On Board Controller Installation
The on board controller can be mounted in two position:
bottom mounting (as per the complete system);
side mounting.
To install the controller proceed as described in the following
procedures.
Bottom Mounting
See the following figure.
1 Turn the pump upside-down;
2 Screw the 4 fixing studs (provided with the accessories bag) into
the holes on the pum bottom;
3 Place the controller on the studs aligning the 4 rubber holes on
the top of the controller case;
4 Press the controller towards the pump;
5 Turn the pump up again;
6 Plug the line cord and connect the pump cable to the pump;
7 Connect the mating connector with the jumper on the interlock
signal to start the pump.
To Next Page
Loading...
