46 agria Multi-Purpose Machine 400E/400K
Apart from observing all operating in-
structions governing the multi-purpose
machine, it is also important to pay at-
tention to the following service and main-
tenance instructions.
W
Please note: Only do all main-
tenance work with the engine
switched off.
To prevent the engine from starting
accidentally, always remove the
spark plug connector disconnected.
When you treat the multi-purpose ma-
chine carefully and clean it after each
operation, the machine will always pro-
vide trouble-free service.
Engine (Type 400K)
Check oil level
l
each time you take up operation
and after every 5 operating hours,
l
only with engine switched off and the
machine is in horizontal position.
l
Clean oil filler plug (D/11) and sur-
rounding parts.
l
Remove oil filler plug.
l
Clean dip-stick with a clean cloth and
screw it back into the oil tank. Remove
dip-stick again and read the oil level.
(Fig.R)
l
In case the oil level is below the lower
mark, refill engine oil (refer to “Specifi-
cations”). – Do not overfill the tank!
l
Re-tighten oil filler plug.
5. Maintenance Type 400K
Changing Engine Oil
The first oil change is after 5 operat-
ing hours. Following oil changes are
after 50 operating hours or at yearly in-
tervals, depending on which operating
period is completed first. After heavy-
duty operation or at
high temperatures
change oil after 25
operating hours.
l
Open the drain
plug (1) and filler plug
(dip-stick) (2) and
drain the oil into a
suitable container or
use a suction pump
to remove the oil
through the filler
neck.
l
Ensure the waste
oil is disposed of
properly!
l
Tighten drain plug
well and fill fresh en-
gine oil. For proper
oil quantity and quality, refer to chapter
“Specifications”
If possible, use a funnel or similar de-
vice to fill in oil.
l
Re-tighten oil filler plug.
Only change oil while engine is still
warm, but not hot – danger of burns!
R
400K
Oil dip-stick
5
5
To Next Page
Loading...
