agria Multi-Purpose Machine 400E/400K 47
Air Filter
Version 5 HP engine
Clean air filter insert after every
3 months or after every 25 operating
hours at the latest (in case of heavy dust
occurence earlier). For this purpose,
proceed as follows:
l
Loosen screws and remove filter
housing cap.
l
Remove foamed preliminary filter
from cap and wash in non-foaming,
warm suds. Do not use paraffine con-
taining detergents (petrol etc.). Rinse
preliminary filter inside out in running
water, rinse until water stays clear.
l
Let insert air-dry completely, before
you insert it again.
l
Slightly soak foamed preliminary fil-
ter with engine oil, squeeze oil out well
(wrap in a cloth and press) to prevent
the dry filter element from becoming wet
due to excess oil.
l
Tap dry filter element, do not blow
clean with compressed air. Do not treat
with oil.
l
Clean dry filter element after every
100 operating hours or after heavy soil-
ing.
Version Power Built engine
see separate Briggs & Stratton engine
operating instructions
5. Maintenance
Fuel System
l
Each time you maintain the machine,
check fuel hose, fuel tank, and
carburetor for leakages. Repair, if nec-
essary, immediately replace leaking or
porose fuel hose.
l
Replace fuel hoses after every 2
years.
l
If engine fuel supply is too high, move
speed control lever to full throttle/Vollgas
and crank engine with recoil starter un-
til engine starts.
Do not crank engine when spark plug is
removed.
T
5
2 fastening
screws
Filter housing cap
Foamed
preliminary filter
(Wire meshed
bottom)
Dry filter element
To Next Page
Loading...
