Agria 400E - Machine; Drive-Wheels

50 agria Multi-Purpose Machine 400E/400K
5. Maintenance
Machine
Worm Gear
W
V
1 Oil filler plug
2 Sealing
3 Transmission housing
4 Hexagon screw
1 Oil filler plug
Drive-Wheels
l Check tyre pressure (0.8 bar) regularly. For smooth driving, make sure that
there is the same air pressure in front and rear tyres respectively.
l For full tractive power, mount wheels fitted with field tyres with the pointed
parts of lugs showing in travel direction (wheels seen from above).
l Constantly check wheel-shaft for wound-on grass, remove the grass by taking
off the drive-wheels, if necessary.
l Lubricate the wheel-shaft ends with Bio-lubricating grease (small shaft diam-
eter) each time before you mount the drive-wheels, once a year, and after clean-
ing with a pressure washer.
l Check transmission oil level before you take
up operation and after every 25 operating hours.
l Park machine on level ground (fig. V) and re-
move oil filler plug (1).
l Oil level must reach filling opening. Refill trans-
mission oil, if necessary.
l Re-tighten oil filler plug.
Exchange transmission oil once per year while
the engine is still warm from operation.
l For this purpose, remove cover from transmis-
sion housing (3) (remove two internal hex bolts).
l Collect old oil in proper container and dispose
of properly.
l Check sealing (2). Exchange sealing and clean
sealing surfaces, if necessary. Replace the cover.
l Position the machine on level ground and re-
move oil filler plug (1).
l Fill fresh transmission oil until oil level reaches
control opening (fig. V). (For proper oil quality, re-
fer to chapter “Specifications”).
l Re-tighten oil filler plug.
5