Agria 400E - Belt Tension and Storage Procedures

52 agria Multi-Purpose Machine 400E/400K
Y
W
Only operate attachments
with all guards in place.
Do not use conventional V-belts but
only agria special belts.
Adjusting V-Belt Tension
Tension of V-belt requires re-adjust-
ment, when the hand clutch lever play
is less than 1.5 mm with forward
speed engaged.
l Remove pulley and belt guard (F/8
or H/8). For this purpose, unscrew lock
nuts (F/10 or H/10).
l Remove V-belt guide plate (F/7 or
H/7).
l Move hand clutch lever (E/4 or G/4)
to neutral/Leerlauf (pawl (E/5 or G/5) is
locked).
l Screw V-belt pulley and rubber pul-
ley “II” into wall until V-belt tension is
normal for reverse speed.
l Prepare rubber pulley “II” for reverse
speed by adjusting the Bowden cable
in the hand clutch lever (fig. X) in such a
way that the space between the outside
diameter of pulley “I” and the outside
diameter of rubber pulley “II” is 5 mm
(fig. Y).
l Engage hand clutch lever for forward
speed.
l Turn idler pulley “III” into arrow direc-
tion, until play in hand clutch lever (in
forward position) is 2.5–4 mm.
l Replace V-belt guide (F/7 or H/7) (see
fig. F or H).
l Mount pulley and belt guard (F/8 or
H/8). For this purpose, the clutch lever
must be in position “forward”.
5. Maintenance
5