MIL-STD-1553 Reference Manual
Chapter 8 – Remote Terminal Functions
Note: The data buffer store mode is always evaluated at the ‘Transfer-End’:
‘bsm’ = 0:
If a transfer error is detected at the ‘Transfer-End’, the Buffer is not
valid!
‘bsm’ = 1:
At ‘Transfer-End’ the Buffer is always valid and it does not matter, if a
transfer error is detected or not. If an error occurred during a RT-
Receive transfer, the RT terminates the transfer with the error
detection. Thus, the possible remainder of the transfer after the error
will not be stored in the buffer.
To Next Page
Loading...
