MIL-STD-1553 Reference Manual
Chapter 9 – Bus Monitor Functions
Reads from the Data Queue
Starts/stops/resumes/flushes the Data Queue
Flush the messages recorded while in Record with Queuing
mode
Stops queueing bus data to the Monitor buffer
Initializes the Record with Queueing process
Read a queued 1553 transfer message in the Monitor buffer
Starts queueing bus data to the Monitor buffer
Setup and initialize the MIL-Scope
Status of the APE MIL-Scope
Calibrate a APX, ACX MIL-Scope
ApiCmdScopeOffsetCompensation
Perform an offset compensation on a APE MIL-Scope
Define a trigger condition for the APX, ACX MIL-Scope
Define a trigger condition for the APX, ACX, APE MIL-Scope
Allocate a buffer to receive APE MIL-Scope data.
Allocate a list of buffers to receive APE MIL-Scope data.
Free a buffer scope data buffer.
Provide a list of scope buffers to the system driver.
Block the current execution thread until the data is available.
To Next Page
Loading...
