Air Techniques, Inc.
Page
54
17.1 Replacement parts.
The following lists the ordering number and description of available external parts that can be replaced by the
user to keep the ScanX operational. Please note that only a trained dealer technician should perform service
that requires replacement of internal parts. Contact your authorized dealer for information.
Description Quantity
Order Number
24V, Power Supply Adapter 1 G8115
6-Foot USB 2.0 Cable 1 B3554
Dust Cover 1 G8150
16.2 Protective dust cover installation.
Pull the protective cover, with the yellow marking towards the front, forwards over the unit until
it is completely covered.
Store the protective cover in a clean dry place when not in use.
Never power down the system during a scanning session.
16.1 Powering down system.
ScanX is designed to be left on continuously during the active day. At the end of the day, or whenever
desired, power down the system as follows:
1. Switch the ScanX from ON to Standby by pressing and holding the ON/OFF button ( ) on
the Control Panel for approximately 2 seconds, until the green LED extinguishes.
2. Remove the main power to ScanX by disconnecting the power supply adapter plug from the
main power outlet socket.
CAUTION
Danger of suffocation
Keep the protective cover away from children.
16. Device Shutdown and Storage
17.2 Accessory and consumable parts.
The following lists the ordering number and description for accessory components and consumable items
available to use and maintain the ScanX to meet your professional needs. Contact your authorized
dealer for information.
Description Quantity Order Number
15-Ft Computer Connector Cable, USB 1 B5027
ScanX Cleaning Sheets 12 G8030
25 G8035
Barrier Film 1 roll of 900 sheets G8195
Parts
Storage
17. Replacement and Accessory Parts
To Next Page
Loading...
