Airspan AirSpeed 2900 - 2 Verifying Prerequisites; Verifying Site Requirements; Verify Installation Requirements; Verify the Tools

AirSpeed 2900 gNB 5G OD Installation Guide
© Copyright Airspan Networks Ltd., 2021 P/N DUG01085 Rev. A, Nov 2021
17
2 Verifying Prerequisites
Prior to installing the AirSpeed 2900 gNB 5G, verify the required safety, power, tools, parts and
components. This chapter includes the hardware, software, and client requirements for installation.
2.1 Verifying Site Requirements
Verify where the AirSpeed unit is to be installed, access and installation method.
2.2 Verify Installation Requirements
2.2.1 Verify the Tools
Table 5. Minimum Hardware Requirements
Tool
Use
10 mm or 13/32 inch
wrench
for securing the M6x16 Hex bolts to assemble the Tilt bracket to
the AirSpeed back
7/16 inch wrench
For securing Tilt bracket to the Pole bracket with the 1/4-20 bolts
1/2 inch wrench
For securing the 5/16-18 threaded rods

Airspan does not provide screws and wall anchors for mounting the unit to the wall. The
screw size depends on the structure of the building to which the unit is to be attached.
When selecting screw sizes, consideration must be given to the weight of the unit and
load that may be induced in windy conditions.