6.2.3 Cuspidor Program
A、 Cup Filling ：
• Press the “Set” button until the indicator illuminates on control
panel
• Press the water supply button and hold, the water supply functio will
be activated ,until the water volume is your expectation, then
release the button and the water supply will stop
• Press the “Set” button one time again, the indicator turns off and
then finish the setting 。
Note: System only keep the latest setting volume
B、 Bowl Rinsing ：
• Press the “Set” button(about 3 seconds) until the indicator
illuminates on control panel
• Press the Bowl Rinsing button
• ① Press the button once and you can hear short beep 1 time,
it mean the first setup: 15 seconds.
② Press the button second time and you can hear short beep
2 times, it mean the second setup: 30 seconds.
③ Press the button forth time and you can hear short beep 4
times, it mean the forth setup: 2 minutes.
④ Press the button forth time and you can hear short beep 4
times, it mean the forth setup: 30 minutes.
then, press the “Set” button again to finish the setting, and the
indicator turns off. Only the latest setting will be stored.
After setting, press Bowl rinsing button for one time, it will rinse
the bowl automatically according to the setting. During the rinsing,
press button again, the rinsing will stop.
32
P/N: 8013093 Rev：F
AJ16 User's Guide
To Next Page
Loading...
Need help?
General