Akuvox C319A - Configure Alarm Action Via HTTP Command; Configure Alarm Action Via SIP Message

AKUVOX SMART INTERCOM www.akuvox.com
90
 Call: enable Call if you want you a call to go to a designated SIP or IP
number.
14.2.7.2. Configure Alarm Action via HTTP Command
To set up the HTTP Command action, you can click “Enable”in the Send HTTP
field to enable the actions for the alarm sensor installed in different locations.
Then enter the HTTP command provided by the manufacturer of the device
on which the action is to be carried.
14.2.7.3. Configure Alarm Action via SIP Message
To set up the SIP message action receiver on the same web interface. Enter
the SIP account to which you want to send the configured SIP message as
an action when the alarm is triggered.