Akuvox C319A - Remote Relay Switch Setting; Web Relay Setting

AKUVOX SMART INTERCOM www.akuvox.com
97
 DTMF: Set the DTMF to trigger the local relay when you enable Remote
control.
15.1.2. Remote Relay Switch Setting
You can use the unlock tab during the call to open the door on web Phone -
Relay - Relay Setting - Remote Relay interface. You are required to set up the
same DTMF code in the door phone and indoor monitor.
Parameter Set-up:
 DTMF Code: To set DTMF code for the remote relay, which is “#” by
default.
15.2.Web Relay Setting
In addition to the relay that is connected to X933/C319, you can also control
the door access using the network-based web relay. To do this configuration
on web Phone - Relay - Web Relay interface.