26
IMPORTANT MAINTENANCE & CLEANING ADVICE
1. The towball should be cleaned regularly to remove grease
or other residue, the use of Thinners, White Spirit or
Brake Cleaner is recommended - otherwise the stabilising
effect will be severely reduced.
2. If friction pads are contaminated, they should not be
cleaned but replaced.
3. The surface of the towball must be free of grooves, rust
or seizing marks.
4. Towballs coated (with paint or similar) must have this
surface completely removed (use 100 or 120 grain
emery paper). If this is not done, increased towball wear
will occur and may cause damage to the AKS 3004
stabiliser components.
5. In Winter, you should carefully spray only the visual
indicator with de-icer.
Fig 32 Lubrication points
LUBRICATION
Should lubrication of the stabiliser parts become necessary,
then the following must be observed.
a. Clean all parts thoroughly.
b. Areas may only be covered with a thin lm of grease (Fig 32).
c. Use multipurpose grease DIN 51825 KTA 3K.
WARNING
When lubricating,
ensure none gets into
the friction pad or
towball holding area.
OPERATING INSTRUCTIONS
FOR AKS 3004 STABILISER
To Next Page
Loading...