36
Fig 42 Lubricate/grease the parts indicated.
SERVICING
Every 10,000 - 15,000 km or every 12 months:
Lubricate/grease all sliding and moving parts of the overrun
device as show in Fig 42.
Recommended lubricant
General purpose grease to DIN 51825 KTA 3KA.
Servicing and care of hot dip galvanized parts
The formation of white rust is only a surface coating and
has no adverse effect on the anti-corrosion properties of
galvanising. To minimise the potential for the formation of
white rust the following precautions should be taken:
- Ensure there is adequate air circulation when storing hot
dip-galvanized parts.
- After winter journeys it is recommended that surfaces are
washed with clean water.
For Troubleshooting & Fault Finding see Table 3 on page 46.
OVERRUN DEVICES
AL-KO
To Next Page
Loading...